With the gentle footsteps of spring quietly approaching, we are about to say goodbye to the PVC hot water bottle that accompanies a winter. Before storage, it is necessary to give the hot water bag a thorough dirt cleaning. This not only allows the hot water bottle to "rest" in a clean state, but also effectively extends its service life, ensuring that it can still be warm as before next winter. Here is a detailed introduction to the method of cleaning PVC hot water bag dirt in spring.

First, surface routine stain cleaning

After a winter of use, the surface of PVC hot water bottle is inevitably contaminated with various dust and daily stains. At this time, preparing a basin of warm water with a temperature of about 30 ° C is the key, and the water temperature should not be too high, otherwise it may cause damage to the PVC material. Soak a soft, damp cloth, such as a cotton towel, in warm water, then gently wring it out until it does not drip. Use this wet cloth along the surface of the hot water bag carefully and gently wipe, pay attention to all aspects of coverage, such as the edge of the hot water bag, corners of these easy to hide dirt and dirt should pay special attention. If you encounter more stubborn stains during the wiping process, you can drop a small amount of mild dishwashing liquid on the wet cloth, and then gently wipe again. Dishwashing liquid can effectively break down oil and help stains fall off quickly. After wiping, be sure to rinse the wet cloth with clean water, and then wipe the hot water bag twice to remove the residual dish soap. Finally, put the hot water bag in a well-ventilated place to dry naturally, pay special attention to avoid direct sunlight, because long-term ultraviolet radiation will accelerate the aging of PVC material, make it brittle.

Two, there are ways to deal with stubborn stains

In the process of using hot water bags, if you are accidentally contaminated with stubborn stains such as tea stains and coffee stains, don't worry, there are special coping methods. First, make a cleaning solution by mixing white vinegar with water in a 1:2 ratio in a small bowl. Soak a clean, soft cloth in the white vinegar solution and remove it. Then apply the cloth to the area with the hard stain and let the vinegar soak through the stain for 10 to 15 minutes. When the time is up, wipe gently with a soft cloth, you will find that the stain gradually fades with the wipe. If the stain remains, repeat the above steps. In addition, alcohol can come in handy if the hot water bottle is unlucky enough to get a special stain, such as paint. With a cotton ball dipped in an appropriate amount of alcohol, gently wipe on the stain, alcohol can dissolve part of the pigment molecules, so as to achieve the effect of removing the stain. However, remember that after using alcohol to clean, be sure to wipe clean with water to prevent alcohol residue from causing adverse effects on the hot water bag.

Third, internal cleaning can not be ignored

In addition to surface dirt, cleaning the inside of the hot water bottle is also crucial. First empty the remaining water in the hot water bag, then prepare an appropriate amount of baking soda, about 5 to 10 grams, slowly pour into the hot water bag. Then, inject an appropriate amount of warm water into the hot water bag, gently shake the hot water bag, so that the baking soda is fully dissolved in water, and make it fully contact with the inner wall of the hot water bag. Baking soda has good decontamination and sterilization effect, and can effectively remove the scale and bacteria that may be generated on the inner wall due to long-term water loading. After shaking for 2 to 3 minutes, drain the water and rinse the hot water bag with water several times, making sure there is no baking soda left inside. It should be especially reminded that when performing internal cleaning operations, the action must be gentle to avoid excessive squeezing or bending the hot water bag to prevent damage to the hot water bag.

Spring is a good time for deep cleaning and maintenance of PVC hot water bags. With the above detailed and practical cleaning method, whether it is everyday stains on the surface, or difficult stubborn dirt, it is easy to solve. Let our PVC hot water bottle clean "rest", when the winter comes again, it will be able to continue to warm our lives in the best state.

Changzhou Yuefeng Plastic Products Co., Ltd. specializes in the production of hot water bottle, PVC hot water bottle, hand warm hot water bottle, cold water sack, insert hot water bottle,,cervical spine hot water bag, plush hot water bottle.